[miker84]

Bench made entirely of 2x4's (except for pegboard)

Case prep area

 

[Beladran]

drill press for a case trimmer??? omg you could trim 20 mm cases with that

 

[miker84]

drill press for a case trimmer??? omg you could trim 20 mm cases with that

:lol4: Good point. It was on clearance at TSC. Beats the heck out of holding on to a hand drill.

 

[Hammer]

I have had that same idea miker!

 

[SubGunFan]

Them are some mighty BIG wrenches for working on guns.......

DANG..... My bench doesn't have a computer on it. Nice addition... (Reload a few rounds and make a few posts on MSGO).

Reloading bench made of all 2x4s. Good idea... 2x4s are easy to work with. Is the bench stable (does it wobble any)?

You DONE GOOD.......... You should be PROUD.

.

 

[miker84]

Them are some mighty BIG wrenches for working on guns.......

DANG..... My bench doesn't have a computer on it. Nice addition... (Reload a few rounds and make a few posts on MSGO).

Reloading bench made of all 2x4s. Good idea... 2x4s are easy to work with. Is the bench stable (does it wobble any)?

You DONE GOOD.......... You should be PROUD.

.

The only wobble is from a low spot in the floor. I've framed a shelf area under the table, but haven't put a sheet of plywood on it. I think it took 15 2x4's and measures 27 deep x 66" wide.

The computer was there because I was "working from the home office" :suspect:

 

[captain-03]

Looks like a good setup ... easy to get around on ...

 

[Xd357]

Nice I like it.

 

[Richard]

Few men and no boys could have done a job that good! Congratulations. How do you like that turret press?

 

[miker84]

Few men and no boys could have done a job that good! Congratulations. How do you like that turret press?

Its a Hornady LNL AP Press. I got it used and have been fixing some broken parts on it. I used it to decap and resize about 1000 223 cases and it was fast. I was just about ready to crank out some 9mm when I found a broken primer guide rail bracket.

 

[Caleb C]

Like the laptop. I think it's a great idea to have a computer on hand in the reloading area. Excel spreadsheets are a good way to keep up with your load data and record testing results. Paper copies get cluttered and confusing.

Nicely done.

 

[cottonmouth]

Looks like a nice set up to me!

J.B.