[Caleb C]

I would like to have a Badger Ordinance (or similar) tactical bolt knob installed on a Rem 700. It requires removing the factory knob and threading to accept the new one. It's a relatively simple job but I don't have the necessary tools. Are there any gunsmiths in the Jackson area who will do this for a reasonable price?

 

[Xd357]

Look here

http://www.msgunowners.com/gunsmithing-f10/gunsmith-list-t3965.htm

let's us know who you go with and how they do.

 

[Caleb C]

I decided to go with Billy Tierce in Utica. I've seen some of his work in Van's. He's really good. I dropped off the bolt on Tuesday so it should be ready next week. I'll post some pics when I get it back and let everyone know how much he charged. I'm sure it will be well worth the money, though.

 

[fgials]

Sweet! I wanna see pics

 

[Caleb C]

Here are the pics as promised. He did a pretty good job. The bolt throw is much better now. It cost me $80.

 

[fgials]

Very nice!

 

[jaym_100]

I will put that on the list of what is going on my new rifle.

 

[jbpmidas]

What kind of stock is that?

 

[Xd357]

I like it. It's on my list to have done.

 

[jbpmidas]

How hard is it to remove the bolt handle? I have seen bolt handles with larger knobs for sale.

 

[Caleb C]

It's a Badger Ordinance knob. The factory knob has to be milled off with a grinder and the bolt lever must be threaded to accept the new knob. You can epoxy the new knob for a permanent solution or just screw it on. I'd recommend using a wicking grade loc-tite for the best of both worlds.

These things are one of the best investments you can made on your bolt rifle (especially a 700). You don't have to worry about dragging your knuckles on the scope and it's much easier to grab in a high stress situation.

 

[Caleb C]

Ohh....

The stock is a Bell & Carlson. I believe it's a Medallist.