Mississippi Gun Owners banner

1 - 7 of 7 Posts

·
Premium Member
Joined
·
21,644 Posts
Discussion Starter #1
Anyone doing it? I recently purchased a Lee 2 cav 440gr gas check mould but have yet to cast the first bullet .... anyone use this mould? I really hated paying 5cnts a piece for gas checks!! How hard an alloy are you using?
 

·
Registered
Joined
·
6,578 Posts
I use this mold and load it with 10 grains of Trail Boss and straight WW's. I'm sure it'd be fine without the gascheck but how would you lube it?

J.B.
 

·
Premium Member
Joined
·
21,644 Posts
Discussion Starter #3
cottonmouth said:
I use this mold and load it with 10 grains of Trail Boss and straight WW's. I'm sure it'd be fine without the gascheck but how would you lube it?

J.B.
I have a lube/sizer -- sizes to 501 ...
 

·
Premium Member
Joined
·
14,543 Posts
I think Cotton is refering to lube in the gas check groove when not using gas checks.

Captain, a Star would take care of that............ :)

.
 

·
Premium Member
Joined
·
21,644 Posts
Discussion Starter #6
SubGunFan said:
I think Cotton is refering to lube in the gas check groove when not using gas checks. Captain, a Star would take care of that............ :) .
Was not thinking of it that way. Actually have never loaded any without the check. You right, the Star would do the job!! Now just give me one of yours!! :thumbup:


Beladran said:
Capt.. give the mold to hammer an let him cut the gas check out..
Don't want to do that -- may need to shoot a grizzly if he comes around my back yard so I may need to load them HOT ... :lol:
 
1 - 7 of 7 Posts
Top