Mississippi Gun Owners banner

1 - 8 of 8 Posts

·
Registered
Joined
·
388 Posts
Discussion Starter #1
Anybody know anyone that can fit a handle on a knife blank? I've had a bowie knife blank for around 10 years and have never put handles on it. It was a kit, and came with the wood handles, but there long gone. I would like to have some type of stag if it didn't cost an arm and a leg. Also maybe a nice leather sheath made for it.
 

·
Registered
Joined
·
388 Posts
Discussion Starter #3
I was looking at this thing earlier after I posted, and I'm not sure it is worth spending the money on. It was made in Japan. It is sharp and would make a good knife for somebody that could do the work themselves. I just don't want to spend the money on it. Anybody interested in a project let me know and I will let ya have it.
 

·
Premium Member
Joined
·
21,644 Posts
nhstk02 said:
I was looking at this thing earlier after I posted, and I'm not sure it is worth spending the money on. It was made in Japan. It is sharp and would make a good knife for somebody that could do the work themselves. I just don't want to spend the money on it. Anybody interested in a project let me know and I will let ya have it.
Post it in the "Pay It Forward" section -- sure someone will jump on it!!
 

·
Registered
Joined
·
394 Posts
Good idea Cap.

E.martin or I either one could put scales on it. True stag scales run about $50 to purchase (that's not installed, thats just to buy them). Jigged cow bone is made to look like stag and runs about $10 for a set of scales. As far as leather sheathes go, that's all E.martin.
 

·
Registered
Joined
·
6,622 Posts
I think some of that japanese steel is good but most is junk. Donavan or Evan could tell you if it worth a your time or give it to a kid to work on.
 
1 - 8 of 8 Posts
Top