Mississippi Gun Owners banner

Found a useful, cheap DIY reloading tool for .223

1031 Views 4 Replies 3 Participants Last post by  jhud
I had some reloads that were left in a wet ammo can. The clips rusted and the powder soaked up moisture.
hammer pulling these .223 rounds was tough, I guess from the corrosion and crimp.

I took the tip of a demilled m16 barrel (cut off at the h-g cap) in hand and used it to "bend" the bullet in the case, breaking free the neck tension. Demilling the ammo became a whole lot easier because I could pull the bullets out by hand.

this is more or less a de-loading tool :)
When I can locate a shot out M1 garand barrel, that will be handy for demilling .30 ammo..
1 - 1 of 5 Posts
Did it scar the bullet?
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top