Agree with Doug -- a lot of LC .308 have been fired in machine guns with very loose chambers. IF they are all timmed to the correct length, have they been run through a full length sizing die?
Lake City 308 Brass
I recently purchased 100 rounds of supposedly once fired 308 brass at a gun show. The brass is all marked "LC 06". I sized it all in a Hornady sizing die and trimmed it all to length. Upon trimming the brass I notice that it all seemed a little long for once fired brass. Some of it was up to 25 mils too long. Anywho.........after the cases were all preped I loaded them with the same powder charge (46.5 gr H380) as my previous loads and capped them off with 150gr Hornady SSTs (the same load I've been shooting for months). When I got to the bench I noticed that NONE of the Lake City cases would chamber in my rifle. They seem to go into the chamber well enough but I can't lock the bolt. I've inspected all of the brass by measuring length and diameter but, I can't seem to find any differences between the Lake City and the Frontier brass that I've been using.
Do you have any idea what the problem my be? Have you heard of anyone else having problems with Lake City brass?
Do you have any idea what the problem my be? Have you heard of anyone else having problems with Lake City brass?
1 - 1 of 17 Posts
1 - 1 of 17 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mississippi Gun Owners
A forum community dedicated to Mississippi State Gun Owners and enthusiasts. Come join the discussion about optics, hunting, gunsmithing, styles, ranges, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
