Mississippi Gun Owners banner

Operating rod beginning to bend

1107 Views 9 Replies 4 Participants Last post by  PhillipM
I've been shooting some of the "Greek" ammunition from CMP in my Garand. This is almost hot ammo. It chronographs at well over 2800, closer to 2900. All other loads I've been shooting have been between 45.5 and 47.0 grains of IMR 4895 using 168 grain bullets. Anybody have any idea what's going on with my operating rod or is it normal for it to have a slight bend to it? If you lay it on a flat board, the bend starts about 1/2' from the gas plug end and increases for about 4" to a height of about 3/16" off the board and then goes back to a straight rod after about 4 more inches. I have not noticed this slight bend before until after I shot about 70 to 80 rounds of the Greek ammo from CMP.
1 - 1 of 10 Posts
+1 for Capt. If it ain't bent it won't fit the rifle.

1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.