Mississippi Gun Owners banner

Outlaw Steel Match Saturday, November 23, 2019 at Magnolia Rifle & Pistol Club in Byram, MS.

727 Views 1 Reply 1 Participant Last post by  Golfer
Outlaw Steel Match Saturday, November 23, 2019 at Magnolia Rifle & Pistol Club in Byram, MS.

Registration is open. If you think you might attend, please register.

Results of this match will be posted to Practiscore.

The match will consist of five stages. 125 rounds minimum.

Magnolia is a cold range and as such guns may not be handled in the parking lot. All guns must be in a case or bag and brought to the designated "Safe" area to be removed from their case or bag and holstered, or if a long gun, placed in a cart with a visible chamber flag as appropriate. Guns may not have any ammunition in them and ammunition may not be handled in the "Safe" area.

The following Divisions will be recognized.
  • Center Fire Pistol - any pistol firing 9mm/.38 Special or larger ammo (no magnums)
CF Open - Optics, Compensators, and any safe holster/position allowed
CF Limited - iron sighted pistol, without compensator, barrel ports, or optical sights
  • Rimfire Pistol - any pistol firing .22LR ammo
    • RF Open - Optics and Compensators allowed
    • RF Irons - Iron sighted, without a compensator, barrel ports or optic sights

  • Pistol Caliber Carbine - 9mm, .357 Sig, .40 S&W, 10mm, .45 ACP
PCCO - Optics
PCCI - Iron sighted

.22s are welcome, but not recommended for this match as they typically can not knock over the steel targets used on the field course.

Setup starts at 7AM and Check In/Registration closes at 8AM. Late arrivals will be turned away, no exceptions.

Please be courteous to your fellow competitors and arrive on time.

There will be a brief Shooters meeting after registration closes and then the match will start.

Match Fee
  • $11
  • Juniors $5
  • For those who arrive early and are assigned to a setup crew $6
See less See more
1 - 2 of 2 Posts
Tomorrow's match is cancelled as not enough participants
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.