[L Smith]

I've been noticing the RRA trigger on my service match rifle has been getting finicky. It was breaking at 1.5 to 2.8 lbs (used to be around 4.5 lbs).
Just putting it out there to be mindful of these. I really like them when not worn but I have roughly 1000 rds with it.
I have a couple of spares I'll use for the next few seasons but will be looking for something different next time.
Anyone else on here experienced this with this or other triggers?

 

[Redlick83]

Have you tried a new set of springs? If you don’t have any I may have some in my spare parts drawer.

 

[L Smith]

Have you tried a new set of springs? If you don’t have any I may have some in my spare parts drawer.

Yes, new springs yielded the same pull weights. Not sure if the sear face is worn or pin holes are worn and causing misalignment. When I get time I'll install it in a stripped lower and investigate further. Thanks for the offer, I keep many spare AR parts.
I still have 4 new of the same triggers, so I installed one of the new ones last night and the pull weight is back to a consistent 4.8 lbs.