[ThatGuy]

I've decided I like my shield so much I'm boutta pimp it out.
So that being said where's the best place to get a shield slide milled.
I'd like a "combat cut" or rear sight behind the red dot.

 

[bubbat]

Might contact the Armory, they sell pimped out Shields. Don't know if they do work like that though.

 

[ThatGuy]

Might contact the Armory, they sell pimped out Shields. Don't know it they do work like that though.

That last sentence there is confusing.
I also don't wanna buy another one I want mine.
It's got sentimental value.

 

[bubbat]

That last sentence there is confusing.
I also don't wanna buy another one I want mine.
It's got sentimental value.

I don't know if they just sell pimped out slides or they can mill slides there in house or can get it done.

 

[ThatGuy]

I don't know if they just sell pimped out slides or they can mill slides there in house or can get it done.

I realized what you meant after replying.
It's past my bed time and I'm delirious

 

[bubbat]

I looked at one Shield they had that's over $3000

 

[ThatGuy]

I looked at one Shield they had that's over $3000

Damn son.
They proud of them.

 

[bubbat]

Damn son.
They proud of them.

Wasn't a part on it not worked on. Guess when you think about it's not really out of line, semi custom 1911s cost that much.

 

[gutdoc]

Are there any out there that are as narrow as the slide on a Shield. Pulling numbers out of an old mind, but I think the Shield width is 0.9 inches and I’m pretty sure the Trijicon rmr fits almost flush on a Glovk 19 which is 1.1 inches. It may not be Problem or issue to you. Just asking!

 

[ThatGuy]

Are there any out there that are as narrow as the slide on a Shield. Pulling numbers out of an old mind, but I think the Shield width is 0.9 inches and I’m pretty sure the Trijicon rmr fits almost flush on a Glovk 19 which is 1.1 inches. It may not be Problem or issue to you. Just asking!

The shield rms.

 

[ThatGuy]

This is what I want ultimately