I have a cheap Wally world center line 4-16 Mildot with a promag quick detatch rings and mount (yes the mount was more than the scope) on my dpms ap4. I swap out with my eo-tech all the time. As long as I mount it back in the same place on the rail, the zero has been no more than 2 in off at 100 yds. Most of the time its stays zeroed after I take it off and put it back on.
Scopes and accuracy
If I put a scope on my AR and get it sighted in, could I remove it for a time then put it back on (the weaver style mounts with finger screws) and have it still be reasonably close to zeroed?
1 - 1 of 20 Posts
1 - 1 of 20 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mississippi Gun Owners
A forum community dedicated to Mississippi State Gun Owners and enthusiasts. Come join the discussion about optics, hunting, gunsmithing, styles, ranges, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
